标准CMOS BIOS设置(国外英语).docVIP

标准CMOS BIOS设置(国外英语资料) Standard CMOS Setup Select STANDARD CMOS SETUP from the main menu and enter the STANDARD CMOS SETUP menu. Date/Time: Date and Time Settings, we can use the cursor to match the Page Up and Page Down to the current Date and Time. The Floppy Drive A, B: sets the Floppy Drive type as None / 720K / 1.2 M / 1.44 M / 2.88 M. HDD Type (hard disk Type) : Auto (Auto test), SCSI (SCSI HDD), cd-rom drive, Floptical (ls-120), or Type 1 ~ 47, etc. LBA/Large: the LBA/Large mode is open. At present, 540M hard drives have to open this option (On), but in the Novell Netware 3.xx or the 4.xx version of the network operating system, you should turn it Off (Off). Block Mode: set this option to On, which helps the disk to access faster, but some old hard drives dont support this Mode, and you must set this option to Off. 32 Bit Mode: this option is set to On, help On a 32-bit operating system (such as WIN95 / NT) to speed up the hard drive transmission speed, some old hard disk does not support this pattern, this option must be set to Off. PIO Mode: supports PIO Mode0 ~ Mode5 (DMA / 33). When you automatically check the hard disk with the BIOS program, you automatically set the PIO Mode on the hard disk. Note: when you attach an IDE device (such as a hard drive, optical drive, etc.) to the system, it is best to enter the BIOS and allow it to detect automatically. If you are using a drawer hard drive, you can set the Type to Auto, or change Primary and Secondary Type to Auto. Primary refers to the first IDE interface, which corresponds to the IDE0 slot on the motherboard, which refers to the second IDE interface, which corresponds to the IDE1 slot on the motherboard. Each IDE interface can be connected to Master/Slave (Master/Slave) two IDE devices. Advanced Setup 1 st rd / 2/3 rd / 4 th Boot Device: the order of the Boot Boot Device, can choose by IDE0 ~ 3, SCSI, optical drive, floppy drive, Floptical high-capacity floppy drive (LS - 120), or by the Network (Network