奥迪A6轿车传感器标准值（国外英文资料）.docVIP

奥迪A6轿车传感器标准值 Standard value of sensor for Audi A6 car Audi A6 sedan First, ANQ engine electronic control system sensor standard value 1. Holzer sensor Test condition Standard value Connect the Holzer sensor connector terminals 1 and 2 with the diode test light and start the engine The diode test lamp flashes 1 times for each turn of the crankshaft 2 turns Connect the digital multimeter to the sensor connector terminals 1 and ground and screw the ignition switch to the ON position to measure the voltage 4.5 ~ 5.5V [img, 252226]file:///C:/DOCUME~1/ADMINI~1/LOCALS~1/Temp/ksohtml/wps_clip_image1.jpg[/img] 2. engine speed sensor Test condition Standard value Disconnect the engine speed sensor and measure the resistance between the engine speed sensor joint terminals 1 and 3 using a digital multimeter 450~1000 Omega [img, 316187]file:///C:/DOCUME~1/ADMINI~1/LOCALS~1/Temp/ksohtml/wps_clip_image2.jpg[/img] 3. inlet temperature sensor Test condition Standard value Measure the resistance between the inlet temperature sensors connector terminals 1 and 2 At 30 degrees centigrade, the resistance is 1500~2000 ohms At 80 degrees centigrade, the resistance is 275~375 ohms [img, 275209]file:///C:/DOCUME~1/ADMINI~1/LOCALS~1/Temp/ksohtml/wps_clip_image3.jpg[/img] 4. oxygen sensor Test condition Standard value Start the engine at idle speed and use a digital multimeter to measure the voltage between the oxygen sensor terminals 1 and 2 11 ~ 15V Start the engine at idle speed and use a digital multimeter to measure the voltage between the oxygen sensor terminals 3 and 4 0.4 ~ 0.5V [img, 300308]file:///C:/DOCUME~1/ADMINI~1/LOCALS~1/Temp/ksohtml/wps_clip_image4.jpg[/img] 5. air flow sensor Test condition Standard value Pull off the air flow sensor connector, screw the ignition switch to the ON position, and measure the voltage between the air flow sensor connector terminal 2 and the ground of the engine with a digital multimeter Battery voltage Pull off the air flow sensor connector, screw