电磁炉屡烧功率管（国外英文资料）.docVIP

电磁炉屡烧功率管 Maintenance of electromagnetic oven furnace burning power pipe (turn) Maintenance experience of induction cooker 1. electromagnetic stove no matter what failure, in the replacement of components, must not rush to the on-line disk test machine, otherwise it will cause burned IGBT and safety tube, and even rectifier bridge. Should be in the case without wiring, power test the voltage, such as 5V, 12V, 20V (18V, 22V), the drive circuit and the output wave type (normal is Fang Bo), can also use the digital multimeter 20V file test (normal voltage fluctuation). Because there is a general cooker cooker detection, about 30 seconds or so, to test the drive output, in the boot of 30 seconds, not clear, can be shut down, open again, after testing normal, and then connect to the disk. 2. electromagnetic oven after bad, dont doubt the detection circuit chip (95% chip fault problem not), even if there was a problem with the chip to produce the electromagnetic oven manufacturers only, to the market to buy, the market model of the same can not replace. After 3. power, the alarm shuts down, this kind of question is more. Some manufacturers have fault code, with reference to the use of instructions can be solved one by one. If there is no fault code display, you should check the pot bottom temperature, pot, IGBT temperature detection circuit. Troubleshooting of MC-PF10E induction cooker A boot, reset automatically after the buzzer ringing Malfunction analysis: There are many reasons for this fault, mainly IGBT temperature detection circuit, cooker temperature detection circuit, power supply high-low voltage protection circuit, zero crossing detection circuit, the following describes its maintenance methods. Fault diagnosis: First, we measure the voltage of the following points with a multimeter, and then we can determine the scope of the fault. The following is the normal voltage of each point: IGBT temperature detection circuit U4 15 foot voltage value: 0.5V Boiler tempera