电除尘（国外英文资料）.docVIP

电除尘 Code for operation of electrostatic precipitator First, the working principle of dust collector YSC series of electric dust collecting mechanism of flue gas dust is by electric field and electron positron collisions between electrodes and charged, effect of charged particle in the electric field under the anisotropic electrode movement and adsorbed on the specific electrode, through vibration, and makes the dust particles from the electrode into ash hopper, the ash conveying system away. In order to achieve the purpose of dedusting, this equipment adopts high voltage negative corona electrode mechanism. Two. The start-up and operation of electrostatic precipitator 1. boiler ignition before 12 - 24 hours, into the high voltage insulator chamber, the top beam and the corona electrode porcelain axle and so on heating device and a temperature detecting device, observation of heating should be normal, controlling the heating temperature is higher than the dew point of the flue gas temperature of 20-30 DEG C 2. boiler ignition before 12 - 24 hours, into the hopper heating device system. 3., 2 hours before the ignition of the boiler, start the corona (cathode) dust collector (anode) vibration device, to confirm the correct direction of rotation, good working conditions, vibration way to use continuous vibration. 4., 2 hours before the ignition of the boiler, start the ash discharge motor and in a low speed state, the ash motor to confirm the correct direction. 5, with the ignition of boiler unit, to observe in low smoke temperature under the condition of lower ash hopper and level indicator, to remove ash and ash removal system and the normal is not blocked. 6, check the hole, door, flange, joint surface and other tight conditions, and found that the timely elimination of air leakage. 7. boiler combustion stability at the end of the ignition, boiler load reached 70% of the rated load, or smoke exhaust temperature (for common coal species) reached 110 degrees, respectiv