大体积混凝土文献汇报概要1.pptVIP

Company Logo Reduction of interior temperature of mass concrete using suspension of phase change materials as cooling fluid 文 献 汇 报 汇报人：吴坤鹏 Company Logo 历年影响因子 Company Logo Contents Abstract 1 Introduction 2 Experimental program 3 Results and discussion 4 Conclusions 5 Abstract In order to evaluate the effect of suspension of phase change material (SPCM) on interior temperature rise and temperature gradient in concrete, a semi-adiabatic device was designed to measure the temperature changing in concrete specimens. Both SPCM and water were used as cooling fluid to evaluate its cooling effect. The temperature difference (TD) and temperature gradient (TG) at different locations were tested and analyzed. The consumption of cooling fluid and corresponding temperature difference between concrete and cooling fluid was also calculated. The results showed that when water was replaced by SPCM as cooling fluid, the temperature reducing extent can be increased 27–28%, and the temperature difference can be decrease 7.6–8.4%. SPCM has a great significance on the cooling of interior temperature rise caused by cement hydration. Introduction In this paper, the effect of using SPCM as cooling fluid to reduce the temperature rise and temperature gradient of mass concrete is discussed. Specimens were performed to compare the cooling effect of water and SPCM. Temperature difference and temperature gradient at different locations were measured. At last, the needed amount of cooling fluid and the theoretical temperature difference between concrete and cooling fluid was calculated. Experimental program 实验方案 Materials材料 PO 42.5 Portland cement its hydration heat of cement at different ages 见图一 PO 42.5 Portland cement the release speed of hydration heat 见图二 The changing of specific heat of SPCM with the temperature 见图三 不同时间的水化热 水化热的释放速度 SPCM的比热随温度变化 配合比 Company Logo 实验步骤 步骤1 步骤2 步骤3 Three specimens with the size of 50cm *50cm *50 cm were mol