工作面老顶来压步距的数值模拟.pdfVIP

第30 卷第3 期 煤 炭 技 术 Vol.30,No.03 2011 年3 期 Coal Technology March,2011 工作面老顶来压步距的数值模拟 陈 亮，孟祥瑞，靳俊恒，冯 磊 （安徽理工大学能源与安全学院，安徽 淮南 232001） 摘 要:为了对老顶来压步距进行预测，以工作面为原型建立数值计算模型，分别模拟不同推进距离对老顶初次来 压步距和周期来压步距的影响，得出采动过程中老顶的初次来压步距和周期来压步距。运用数值模拟方法,可以较 为全面地揭示采动条件下老顶变形破坏特征及破坏范围，有利于选择和优化设计方案，同时减少试验时间，提高矿 井的经济效益与社会效益。 关键词:老顶初次来压步距；老顶周期来压步距；数值模拟；FLAC3D 中图分类号:TD327.2 文献标识码:A 文章编号:1008-8725 （2011）03-0073-03 Numerical Simulation on Intervals of Main Roof Weighting CHEN Liang, MENG Xiang-rui, JIN Jun-heng, FENG Lei （College of Energy and Safety, Anhui University of Science and Technology, Huainan 232001, China） Abstract:In order to forecast the intervals of main roof weighting, to build numerical model by working face, the influence for the initial and periodic weighting length of the main roof are simulated in the different face advance distance, the initial and periodic weighting length of the main roof during the mining active process is abtained. The results showed that numerical simulation can more comprehensively reveal the stress fields, deformation and failure characteristics, and failure range and depth of rock mass in coal seam floor undermining, these are favorable to select and optimize design mining scheme and reduce the testing time, so improve the economic and social benefits of mines. Key words:initial weighting length of the main roof; periodic weighting length of the main roof; numerical simulation; FLAC3D !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! 占额定工作阻力的65.15 %左右，所选支架能充分满 足生产的要求，但支架工作阻力利用率较低；工作面