盐雾试验（Salt spray test）.doc

盐雾试验（Salt spray test） The coating technology is in the fifth phase of volume 25, 2004 The evaluation of the case is less than the right Wang liqun, li da Ming, feng chunmiao, wu kuo (zhonghua changzhou paint chemical research institute, 213016) Abstract: in this paper, the test of salt spray, ASTM d2933-74 (81), dynamic corrosion resistance test of lacquered steel plate, humidity and heat test, etc In this paper, the application of the method of modern analytical methods of materials in the evaluation of precoated rolling materials and the modern methods for evaluating the anticorrosion performance of precoated rolling materials are used. Key words: pre-coated; Anti-corrosion performance; Salt spray test; Corrosion test: wet and heat test 0 the introduction In recent years, with the continuous high growth of China's economic construction, The application field and demand of precoated coil are expanding, and the market demand is not The main application of domestic precoiled materials is the construction industry. In recent years, the home appliance industry has also begun to use pre-coating, and the demand There will be a significant increase in applications in areas such as transportation Start slowly. The precoated surface is well coated and can be added directly It is required to have high strength and good machinery Machining performance, meanwhile, requires good corrosion resistance and corrosion resistance Physical shielding performance. The mechanical property evaluation of precoated rolls is more intuitive, such as T bend test Test, impact resistance, cup test, adhesion test, etc The speed is convenient to carry out, but the anticorrosion performance of the coating film is much more complicated. Traditional methods such as salt spray test and humid heat test are needed Long test time can only get qualitative results. In recent years, Abroad with some new analysis instruments, methods widely used, such as Electrochemical impedance spectroscopy (EIS), fluoresc