基于加工特征向量的制造设备分组算法研究.pdfVIP

现代制造工程(Modem Manufacturing Engineering) 2016 年第 l 期 试验研究 基于加工特征向量的制造设备分组算法研究. 霍德慧l ，张发平l ，阎艳l ，高博1 ，张体广1 ，吴建平2 (I北京理工大学机械与车辆学院，北京l(削81 ;2 北京京城新能源有限公司，北京 1∞040) 擒要:针对目前网络化制造环搅下设备分组和检索算法效率不高的现状，提出了基于设备加工特征向量的分组方法来 提高算法的效率。 首先，按照设备所能完成的加工特征，从特征的形状、尺寸以及加工精度等三个维度构建了制造设备 的加工特征描述向量;然后基于制造设备的加工特征描述向量，通过设计了初始分组中心选择策略和采用非遍历分组 组数优化技术，改进了扩展模糊C-均值算法，构建了基于加工特征向量的设备分组模糊聚类算法。 该算法可高效、精确 地计算出设备最优分组组数。 最后，以50 台制造设备的分组为例验证了该算法的有效性。 关键词:模糊 C-均值聚类:加工特征向量;设备分组 中困分类号:THI6 文献标志码:A 文章编号:1671--3133(2016)01一αlOl-{)7 DOI: 10. 167311j. cnki. 1671 -3133.2016.01.∞1 Machining feature vector.based a1gorithm for manufacturing equipment grouping l l l l 2 Zhai Dehui ,Zhang Faping ,Yan Yan ,Gao BOI ,Zhang Tiguang ,Wu Jianping (1 School of Mechanical Engineering , Beijing Institute of Technology , Beijing 1仪泊81 ， China; 2 Beijing Jingcheng New Energy Co. Ltd. , Beijing H削40 ， China) Abstract: :Aiming at improving 由e efficiency of the algorithm for fast grouping and retrieval of manufacturing equipment ,a notion of Manufacturing Feature Vector (MFV ) based eq山pment description was proposed to improve the efficiency of 由e algorithm. First ,general manufacturing features were induced and further classified according to the principles of feature classification de- signed on the geometry type of manufacturing feature . The combination of the manufacturing features which could be machined by the equipment was defined as the MFV of the device. Type ,size and precision were used as the three attributes of the MFV. 币len ， extended fuzzy C-means clustering algorithm was am