AD9238（AD9238）.docVIP

AD9238（AD9238） Introduction In electronic measurement system, high speed signal acquisition and processing is often needed, and the precision of data acquisition and processing system is very high in many fields. Therefore, it is very important to design a good high-speed and high-precision acquisition system. For high-speed data acquisition system, people usually choose FPGA, DSP and other high-speed devices to achieve the method compared with MCU, the cost is higher. In fact, in some systems, do not require real-time data acquisition, at this point, with inexpensive MCU can be achieved. In this paper, a high-speed ad sampling circuit, which is controlled by MCU and used FIFO as buffer, is designed to realize the link between high-speed ad sampling and slower MCU data processing. 1 System Fundamentals For high-speed data acquisition, if the ad sampling data synchronously read out, for MCU, the speed is far from enough. Therefore, the system uses high-speed FIFO as a buffer, the FIFO first to store the high-speed ad sampling data, and then the MCU to the data from the FIFO low speed readout. Then, through the front-end conditioning circuit, the input single-ended analog signal is converted to a differential signal suitable for ad input range. This system MCU uses EZ Chip An2131q to realize. An2131q is the EZ Series USB Bus Controller of Cypress Company, with 8 K byte program RAM, external storage capacity up to 64KB, 24 common I/O ports. The AN2123Q chip can package the information required by the USB bus interface. Then the USB bus transceiver and USB bus pin + and D-connected, and then use the serial interface engine to decode and decode the serial data, error check, bit fill and complete the other signals required by the USB bus, finally realize the bus interface data transmission. The An213 embedded Enhanced 8051 kernel can be set using standard 8051 instructions, faster than the standard 8051. An2131q can pass data from FIFO to PC via USB port and block transfe