120171021317 陈力 计算机网络.docVIP

计算机网络 实 验 报 告 专业班级： 12计应2班 姓 名： 陈 力 学 号： 120171021317 指导老师： 裴灿浩 实验 计算机不同网段局域网互通 目的：通过仿真软件Packet Tracer模拟实际局域网互通的情形，接近实际地使用ping的命令，从而加深对ping的命令的使用的理解 实验步骤： 1．实验的具体配置拓扑图 其中 Router0 Router1 2．配置过程 ⑴准备工作 先配置Router0，Router1的基本信息，注意Router0作为DCE提供时钟频率(64K) Router0 Routeren Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#host r1 r1(config)#int f0/0 r1(config-if)#ip add 192.168.1.254 255.255.255.0 r1(config-if)#no shut %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up r1(config-if)#int s0/0 r1(config-if)#ip add 192.168.3.1 255.255.255.0 r1(config-if)#clock rate 64000 r1(config-if)#no shut %LINK-5-CHANGED: Interface Serial0/0, changed state to down r1(config-if)#end %SYS-5-CONFIG_I: Configured from console by console r1#copy run start Destination filename [startup-config]? Building configuration... [OK] Router1 Routeren Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#host r2 r2(config)#int f0/0 r2(config-if)#ip add 192.168.2.254 255.255.255.0 r2(config-if)#no shut %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up r2(config-if)#int s0/0 r2(config-if)#ip add 192.168.3.2 255.255.255.0 r2(config-if)#no shut %LINK-5-CHANGED: Interface Serial0/0, changed state to up r2(config-if)# %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up r2(config-if)#end %SYS-5-CONFIG_I: Configured from console by console r2#copy run start Destination filename [startup-config]? Building configuration... [OK] 再分别配置PC0、PC1、PC2和PC3的基本信息 PC0 PC1 PC2 PC3 ⑵ 配置Router0的RIP路由并验证 r1#conf t Enter configuration commands, one per line. End with CNTL/Z. router1(config)#router rip router1(config-rout