方式图集（Mode Atlas）.docVIP

方式图集（Mode Atlas） Question: as frame beam end support frame column width is small, do not meet 0.4LaE? Answer: This is a common phenomenon: What should be done when the width of the frame column of the frame beam end support is small and does not meet the requirement of 0.4LaE? A false point of view: when the column width is small, the longitudinal reinforcement is straight and the anchor horizontal section is less than LaE, then the length of the missing part is bent.. (that is, the sum of the horizontal and straight hook lengths equals LaE) Even think: if the longitudinal reinforcement anchor horizontal segment is less than 0.4 LaE, then the length of the LaE- straight anchor length is bent.. There are two mistakes here: (1) LaE is the standard length of straight anchor. When bending anchor, LaE shall not be used as a standard for measuring the total length of the anchor (2) shall ensure straight anchor horizontal section is greater than or equal to 0.4LaE is necessary, if not satisfied, should be reinforced to meet the larger diameter intensity or area substitution bar diameter smaller, but should not be used to make the total length of the extended straight hook length of anchor is equal to the error LaE. As mentioned in the previous question and answer, it is a waste of the length of the straight hook longer than 15d Why for the substitution of smaller diameter steel anchor can make straight horizontal length to meet the 0.4LaE condition? Because the LaE and diameter of steel bar, for example, when the concrete strength grade C20, two grade steel (within 25mm) LaE 44d, at this time, if the bar diameter is 25mm, LaE is 1100mm; but if the conversion into 22mm steel one grade, the LaE becomes 968mm. But, then again, according to the strength or area substitution, the bar diameter is smaller, but the number of steel bar will become more, sometimes a row of bars do not put, but also much to arrange a row of steel -- and each row layout bar, row straight anchor the ho