售货机底层代码（Vending machine bottom code）.docVIP

售货机底层代码（Vending machine bottom code） ORG 0000H; sets the initial address to 0000H LJMP MAIN; leave room for interruption ORG 0100H MAIN: MOV, SP, #80H; build the stack MOV, PSW, #00H MOV, IE, #00H MOV A, #0FFH P0; - I write 1 as input and output ports MOV, P0, A ORL, P3, #0FFH; make the P3 port the input port MOV, TMOD, ; make timer 1 work in mode 2 MOV, TH1, #0E8H; set the count value, so that the baud rate is 1200bit MOV, TL1, #0E8H SETB TR1; start timer 1 MOV, SCON, ; set the serial port as mode 1 CLR RI; clears the receive interrupt flag bit and begins to receive data ---------------------------; main loop, receiving PC command, and detecting the motor stop command similiarly LOOP: JB, RI, a_rec; check for new data. The host computer commands to receive ON0: JB P3.7, on1; motor C scan detection LJMP key0 ON1:, JB, P3.6, on2 LJMP key1 ON2:, JB, P3.5, on3 LJMP key2 ON3:, JB, P3.4, on4 LJMP Key3 ON4:, JB, P3.3, on5 LJMP key4 ON5:, JB, P3.2, on6 LJMP key5 ON6:, JB, P2.0, on7 LJMP Key6 ON7:, JB, P2.1, on8 LJMP Key7 ON8:, JB, P2.2, on9 LJMP Key8 ON9:, JB, p2.3, DNF1 LJMP key9 DNF1: SJMP LOOP ---------------------------; PC command receiving and detecting part A_rec: CLR RI; clears the flag bits MOV, A, SBUF; feed the received data into the accumulator NEXT0:, CJNE, A, #0, NEXT1 AJMP LOAD0 NEXT1:, CJNE, A, #1, NEXT2 AJMP LOAD1 NEXT2:, CJNE, A, #2, NEXT3 AJMP LOAD2 NEXT3:, CJNE, A, #3, NEXT4 AJMP LOAD3 NEXT4:, CJNE, A, #4, NEXT5 AJMP LOAD4 NEXT5:, CJNE, A, #5, NEXT6 AJMP LOAD5 此：cjne，# 6 ，next7 ajmp load6 next7：cjne，# 7年，next8 ajmp负载 next8：cjne，# 8”，next9 ajmp装载量80 next9：cjne，# 9，未来10 ajmp load9 未来10：cjne，# a，next11 ajmp load10 next11：cjne，# B，12 ajmp load11 12：cjne，# C，next13 ajmp load12 next13：cjne，#会，next14 ajmp load13 next14：cjne，# e、15 ajmp load14 未来：cjne，# F，next16 ajmp load15 next16：cjne，# 克，next17 ajmp load16 next17：cjne，# H，未来的18 ajmp load17 未来的18：cjne，# i，next19 ajmp最大负载 next19：cjne，# J’，不 ajmp load19 别：定时未到 ---------------------------功能程序部