四川大学ipv6（Sichuan University, IPv6）.docVIP

四川大学ipv6（Sichuan University, IPv6） If youre XP, type CMD in the run, and then enter in the command line window: Netsh, interface, IPv6, ISATAP, set, router, isatap.sjtu.edu.cn (carriage return) Netsh, interface, IPv6, ISATAP, set, state, enabled (carriage return) All right ~! Netsh, interface, IPv6, ISATAP, set, router, isatap.sjtu.edu.cn Netsh, interface, IPv6, ISATAP, set, state, enabled Vista or win7, run CMD as an administrator, and type in the two lines of command The Windows XP/2003 is set as follows: The mouse click on the Start program annex command prompt, this time in the open DOS window of the command prompt input Netsh, the specific steps are as follows: C:\Documents and Settings\Administratornetsh Netshint Netsh interfaceipv6 Netsh interfaceipv6install Netsh interface ipv6isatap Netsh, interface, IPv6, isatapset, router, 202.115.39.98 With regard to IPv6, it can be used perfectly if it is under XP, but not available under vista and win7, as well as under Mac and linux. The solution for windows and Linux is as follows: ============================================ We have a problem with Ipv6 Sichuan, set to Shanghai Jiaotong University, OK ============================================ IPv6s ISATAP tunnel and 6to4 tunnel test The 1. ISATAP tunnel point IP address is isatap.sjtu.edu.cn The user sets the end point of the ISATAP tunnel, router, for isatap.sjtu.edu.cn The Windows XP/2003 is set as follows: C:\Documents and Settings\Administratornetsh Netshint Netsh interfaceipv6 Netsh interfaceipv6install Netsh interface ipv6isatap Netsh, interface, IPv6, isatapset, router, isatap.sjtu.edu.cn The Vista settings are as follows: Right click on the Start program annex command prompt, select run as administrator. In the new open command prompt window, execute the following two commands: Netsh, interface, IPv6, ISATAP, set, router, isatap.sjtu.edu.cn Netsh, interface, IPv6, ISATAP, set, state, enabled (some computers in the Vista system send IPv6 RA in the loc