Investigation of Surface Roughness in Machining （调查在加工表面粗糙度）.pdfVIP

Investigation of Surface Roughness in Machining Oil Palm Wood 1 1 2 1 M.Z.Harizam , Y.Nukman , M.Anis , K.F.Tamrin 1Department of Engineering Design and Manufacture, Faculty of Engineering, University of Malaya 2Malaysian Palm Oil Board, Malaysia Abstract Oil palm industry is one of the largest agricultural plantation sectors in Malaysia. The total area under oil palm cultivation is over 2.65 million hectares, producing over 8 million tons of oil annually. The oil palm trunk is converted to oil palm wood after the replantation take place. The machining of wood process by cutting is a demanding technological process because of its specific structure. In many industries, accuracy and precision are crucial parameters for their production to achieve the best quality of cut. One of the qualities to be monitored is the surface roughness, Ra value which has direct implication on cut quality. Hence, this study was embarked to quantify the surface roughness of machining of oil palm wood. Three types of machining oil palm wood processes were conducted by using CO2 laser cutting, CNC milling and vertical saw machine. As a result, CO2 laser cut produced the best cut quality in comparison to other competing machining processes. Keyword: Oil Palm wood, CO2 laser, CNC Machine, Vertical Saw Machine, Surface Roughness 1.0 Introduction 2006). In addition, its structure property is different in comparison to forestry trees since Manufacturing of an oil palm wood it does not have a secondary growth which was initiated by Malaysian Palm Oil Board typically displays growth rings,