LSDYNA Simulations of Thermal Shock in Solids（LSDYNA模拟固体的热冲击）.pdfVIP

LS-DYNA Simulations of Thermal Shock in Solids Goran Skoro University of Sheffield Contents: Introduction LS-Dyna results • Neutrino Factory target • Test measurements (current pulse; tantalum wire) • ISOLDE test • T2K target + (current pulse; graphite wire) Summary, Plans Introduction NF RD Proposal • The target is bombarded at up 50 Hz by a proton beam consisting of ~1ns long bunches in a pulse of a few micro-s length. • The target material exposed to the beam will be ~ 20cm long and ~2cm in diameter. • Energy density per pulse ~ 300 J/cc. • Thermally induced shock (stress) in target material (tantalum). • Knowledge of material properties and stress effects: measurements and simulations! Codes used for study of shock waves • Specialist codes eg used by Fluid Gravity Engineering Limited – Arbitrary Lagrangian-Eulerian (ALE) codes (developed for military) Developed for dynamic e.g. impact problems Useful for large deformations where mesh would become highly distorted Expensive and specialised • LS-Dyna Uses Explicit Time Integration – suitable for dynamic e.g. Impact problems Should be similar to Fluid Gravity code • ANSYS Uses Implicit Time Integration Suitable for ‘Quasi static’ problems LS-DYNA • General purpose explicit dynamic finite element program • Used to solve highly nonlinear transient dynamics problems Advanced material modeling capabilities Robust for very large deformation analyses • LS-DYNA solver Fastest explicit solver in marketplace More features than any other explicit code Material model used in the analysis • Temperature Dependent Bilinear Isotropic Model Classical inel