Measurement and testing techniques used in （用于测量和测试技术）.pdfVIP

Combined measurements in civil engineering Measurement and testing techniques used in verifying the load-bearing capacity of a bridge over the Main-Danube Canal by Kla us Steffens, Marco Tschötschel, Rainer Ehmann, Heinz Opitz, Joche n Quade and Peter Schwesinger Damage found on the Baiersdorf Bridge over the Main-Danube Canal was the reason for verifying the load-bearing capacity of the roadway structure. This work was carried out withi n the scope of the EXTRA co-operative research project w hich was supported by t he BMBF. The methods used were based on on-line measurement technology which supplied real-time information about the loading state and the reaction of the structure, and also on fail-safe loading equipment for the non-destructive application of the test limit-load. The article describes the methods used w hich successfully demonstrated that the very ex pensive alternatives of a new re placement bridge or extensive repairs were unnecessary . Introduction canal itself and the service paths on each bank. The total w idth of the bridge is 9.0 m (30 ft), consisting of the 6.0 m (20 ft) road and the sidewalks which are each 1.5 m (5 ft) The Baiersdorf Bridge was built in 1964 and, forming part of w ide. the Baiersdorf- Röttenbach district ro