MICROCRUISE 4 Rostra（MICROCRUISE 4 嘴）.pdfVIP

MICROCRUISE 4 INSTALLATION and OWNER’S MANUAL FORM #2756, REV. E, 07-30-09 THIS MANUAL, YOUR KIT AND YOU This Cruise Control Kit is a microprocessor based Cruise Control. It is designed for ease of installation and can be used with most cars, light trucks and vans. Carefully follow the installation procedures in this manual for best results. TO VIEW THE INSTALLATION VIDEO VISIT OUR WEBSITE AT WWW.ROSTRA.COM DO NOT INSTALL THIS SYSTEM ON A DIESEL POWERED VEHICLE WHICH HAS A MANUAL TRANSMISSION WITHOUT A DISENGAGEMENT SWITCH (250-4206) ON THE CLUTCH PEDAL ASSEMBLY Your vehicle must have a VSS (Vehicle Speed Sensor) wire or an available signal generator for installation of this Cruise Control. Please consult vendors Application Guide. Low displacement engines with limited vacuum will get better performance if a vacuum reservoir is installed. Vacuum reservoirs, pumps, regulators and other acces- sories are available from your dealer, automotive service center or most automotive parts outlets. All through the instructions there are WARNINGS, CAUTIONS, AND NOTES that are meant to make it easier for you to put the Cruise Control on your vehicle and safer to use. We have gathered these tips from people across the country who have told us about their problems and how they worked them out. Even with all these reports from the field, we cannot cover every condition which you might encounter, there are just too many different vehicle makes and models. We do our best to tell you how to handle most vehicles, but we must Depend On Your Good Judgment for dealing with the rest. Therefore, we believe you can understand why we strongly urge you to think carefully about what could happen to you, your passengers and your vehicle if you use any tools, parts, fastening methods, routing or procedures which are not described in this manual. There is NO drain on the ba