Microwave Network Design cdn.ttgtmedia（微波网络设计cdn.ttgtmedia）.pdfVIP

Professional Engineering 6X9 / Microwave Transmission Networks / Lehpamer / 122-2 / Chapter 5 Chapter 5 Microwave Network Design 5.1 Introduction After the preliminary microwave network plan has been approved, detailed microwave network design has to be completed. Site acquisi- tion, microwave network design, RF design (in case of wireless network build-out), and interference analysis are done simultaneously. In most cases, the results are mutually dependent. That means that none of these activities can be done without consultations with and input from the other three. It also means that a project manager has to make sure that these groups of experts talk to each other on a daily basis, which can sometimes present a challenge. The results and deliverables of the microwave network design process will be used during the deployment stage for the actual installation and testing of the microwave system. Microwave path (link) calculations are performed as a part of detailed microwave system design, and all the detailed hardware requirements (bill of materials) are defined based on this information. The microwave design software tools are used for detailed path engineering and interference analysis. 5.2 Spectrum Management 5.2.1 Availability of Spectrum Throughout the last 100 years, the perception has always been that there is not enough spectrum available. However, technology contin- ues to resolve this problem by making more spectrum usable. For example, the uppe