National Institute of Technology Rourkela （Rourkela研究所技术）.pdfVIP

3-D ANALYSIS OF BUILDING FRAME USING STAAD-PRO A Thesis submitted in partial fulfillment of the requirements for the degree of Bachelor of Technology in “Civil Engineering” By ASHIS DEBASHIS BEHERA (108CE021) Under the guidance of Prof. K.C. BISWAL Department of Civil Engineering National Institute of Technology Rourkela-769008 (ODISHA) May-2012 DEPARTMENT OF CIVIL ENGINEERING NATIONAL INSTITUTE OF TECHNOLOGY, ROURKELA ODISHA, INDIA-769008 CERTIFICATE This is to certify that the thesis entitled “3-D Analysis of Building Frame Using STAAD-PRO ”, submitted by Ashis Debashis Behera (108CE021) in partial fulfillment of the requirements for the award of Bachelor of Technology in Civil Engineering during session 2011-2012 at National Institute of Technology, Rourkela. A bonafide record of research work carried out by them under my supervision and guidance. The candidates have fulfilled all the prescribed requirements. The Thesis which is based on candidates’ own work, have not submitted elsewhere for a degree/diploma. In my opinion, the thesis is of standard required for the award of a bachelor of technology degree in CIVIL Engineering. Place: Rourkela Dept. of Civil Engineering Prof. K.C.Biswal National institute of Technology Associate Professor ACKNOWLEDGEMENTS On the submission of my thesis entitled “3-D Analysis Of Building Frame Using STAAD- PRO”, I would like to extend my gratitude my sincere thanks to my supervisor Prof. K.C. Bisw