Power Case Trimmer PT1010001 （功率微调pt1010 001）.pdfVIP

FORSTER POWER CASE TRIMMER INSTRUCTIONS Select the correct collet for the case to be trimmed (see the table on the back) and place it in the collet screw. For a smooth operation, a very small amount of grease should be applied to the front face and tapered portion of the collet before installing it in the collet screw. Turn the collet screw containing the collet into the collet housing by hand until the collet touches the housing without closing. Fasten this assembly to the base post with the 10-32 x 3/4” socket head cap screw. Screw the threaded handle into the collet screw. To line up your trimmer with the drill press spindle, place one end of the line-up bar in the collet and lock it. The upper end of the line-up bar is then placed in the drill press chuck and locked. The Power Case Trimmer is now accurately lined up and ready to be fastened to the drill press table. The hole in the base has a 3/8”-16 thread for attaching the base to drill press tables that have a hole in the center. On drill presses without a center hole, the base can be fastened to a flat, hardwood board and the board then held by C-Clamps. Either of these methods has proven satisfactory in use. Install the correct Pilot in the cutter holding it tightly against the edges of the cutter. With ten- sion on the collet released, insert the base of the cartridge case into the collet. Hold the car- tridge case against the shoulder of the collet with one hand and lock the collet with the other. It is important that the base of the cartridge is firmly seated against the shoulder of the collet in order to obtain consistent and accurate results. The drill press spindle stop controls the depth of cut and should be set carefully in order to trim the cases to proper length. Take a light trial cut and measure the length of the case. Sharp corners are easily removed by using the Forster Inside-Outside Deburring Tool. Powder re