刮家小议（Scrape home Delphi）.docVIP

刮家小议（Scrape home Delphi） General steps and precautions to be found online: Blank wall cracks - brush interface agent 1 times - processing - leveling (including Yin and Yang Angle looking for straight) - patch - 2-3 times putty scraping - - primer - a little polishing (any place must use primer on 1) again, twice paint, curing Interface agent: brush interface agent must be brushed, and should be brushed. Bbs0. House. S I9 G2 ` x; $M5 og Crack seam: normally use the kraft paper tape and white latex to stick the crack (but cannot guarantee that 100% will not crack again). Find flat: the metope of uneven bump needs to be flat, general gesso is more commonly used, concave and convex difference is not more than 0.5cm is good. Patch: general light body wall and thermal insulation wall nonbearing wall are need to patch, try to choose better wall cloth texture and white latex, if conditional word can use a grid cloth, the relative crack effect will be better. Sina le house BBS 4 W U8 p + L (U6 L2 u# ^ 7 T Greasy son: choose the fine grain fineness and the hard putty of the texture is good, also can add certain white latex in the putty, can improve the hardness of putty. 6 i3 X + ` : h [, I * I _ c: X Grinding: as far as possible with a fine sandpaper, general texture is soft putty (e.g., 821) in 400-500 sandpaper, a hard (such as wall lining, yi gung flat) in 360-400 to be beautiful, if sandpaper too coarse sand will leave a deep mark, brush paint wont cover off. After sanding, must thoroughly clean the wall, in order to avoid too much dust, influence the adhesion of paint. The concave and convex difference is no more than 3 mm. Somebody give a comment? Thank you!! First grass root treatment (raw wall uneven, plaster for plaster; if it is gypsum walls do not need) Next use inside porcelain powder to clean metope Then the sand paper is polished and smoothed (some places such as the Yin and Yang angles of the top of the wall and the aluminum alloy bars and the cast of the gyp