fdd和tdd的比较（Comparison of FDD and TDD）.docVIP

fdd和tdd的比较（Comparison of FDD and TDD） Comparison of FDD and TDD Frequency division duplex FDD (Frequency Division Duplexing): also known as full duplex, operation requires two independent channels. A channel is used to transmit information downward, and another channel is used to transfer information upward. A guard band exists between two channels to prevent interference between adjacent transmitters and receivers. By the end of 2013, 499 operators were investing in LTE in 143 countries and regions. Of these, 448 operators have committed to deploying LTE networks in 134 countries and regions, and 51 are testing and testing LTE in 9 countries and regions. Of the promised carriers, 244 have launched commercial services, up 78% from the same period last year. The global mobile equipment suppliers association predicts that 260 LTE networks will be commercially available by the end of the year. Most LTE operators have deployed the FDD standard. The most widely used frequency band in the network deployment is still 1800MHz, accounting for 44% of the commercial LTE network. 108 operators in 58 countries and regions have enabled 1800MHz systems to grow by 157% compared to the same period last year, either as a single frequency band or as part of a multi band deployment. [1] Catalogue 1 Introduction 2 contrast Features Scope of application Advantages and disadvantages 3 function 43G effect 54G effect 6 relevant knowledge Computer hardware The characteristics of software development? 1 Introduction editor FDD model is in isolation (downlink frequency interval 190MHz) two symmetric frequency channel, receiving and transmitting system, with the band to separate receive and transmit channel. Using packet switching technology, it can break through the bottleneck of the two generation development, realize high-speed data service, and improve the spectrum utilization and increase the system capacity. But FDD must adopt a pair of frequencies, that is, to provide third generation se