塑料模具设计步骤（The plastic mold design process）.doc

塑料模具设计步骤（The plastic mold design process） The plastic mold design process A book, to accept the task Molding plastic parts task is normally made by product designers, its contents are as follows: The formal system after signing 1. parts drawings, and indicate the use of plastic trademark, transparency. 2. plastic product specifications and technical requirements. 3. production. 4. samples of plastic parts. Usually the mold design task put forward by the plastic parts plastic parts molding process according to the task book, die design in molding plastic articles task, mold design task book as the basis to design the mold. Two, collect and analyze, digest raw data Collect related product design, molding process, molding equipment, machinery processing and special processing, in preparation for the die design. Figure 1. digestive plastic parts, understand the purpose, process analysis of plastic parts of the size, accuracy and other technical requirements. For example, plastic products in appearance, color and transparency, What is the use of performance requirements, the plastic parts of the geometric structure, slope, etc. the insert is reasonable, weld line, allowing the degree of shrinkage hole forming defects, without coating, electroplating, Adhesive, drilling and other processing. Select the size of plastic parts size with the highest accuracy analysis, see estimate is lower than the plastic parts molding tolerances Tolerances, molded plastic parts can meet the requirements of the. In addition, but also understand the parameters of plasticization and molding process of plastic. 2. digestion process data, analysis of molding method, process task book made by equipment type, material specifications, die structure types can implement requirements are appropriate. It should meet the requirements of plastic parts molding material strength, strong liquidity, good homogeneity and isotropy, thermal stability. According to the use of plastic parts, molding material shou