satwe处理（SATWE）.docVIP

satwe处理（SATWE） SATWE treatment, the main control of the following parameters on it, and for the novice, repeatedly read, slowly digest. Guizhou architectural design group (143562456) Seven ratios and adjustment methods needed to control the design of high-rise buildings The difficulty of high-rise design lies in the rational arrangement of vertical bearing members (columns, shear walls, etc.), and the target parameters in the design process are as follows: seven: An axial compression ratio mainly to limit the structure of the axial compression ratio, guarantee the ductility of the structure, the corresponding standard limits of shear wall and column has see resistance gauge 6.3.7 and 6.4.6, 6.4.2 and 7.2.14 showed high regulation and relevant provisions. When the axial compression ratio does not meet the requirement, the ductility requirement of the structure can not be guaranteed; the axial compression ratio is too small, which shows that the economic and technical indexes of the structure are poor, so it is appropriate to reduce the sectional area of the corresponding wall and column properly. Adjustment method when axial pressure ratio is not satisfied: 1, program adjustment: SATWE program can not be achieved. 2, manual adjustment: increase the wall, column section, or raise the floor wall and column concrete strength. Two, shear weight ratio: mainly to limit the floor of the minimum level of seismic shear, to ensure a longer period of structural safety, see the anti gauge 5.2.5, high regulation 3.3.13 and the corresponding provisions. This requirement, like the minimum reinforcement ratio, requires that the horizontal seismic shear force be artificially improved if it fails to meet the minimum requirements of the specification and that subsequent calculations shall be carried out at this minimum requirement. Adjustment method when the shear weight ratio is not satisfied: 1, adjust the program: the SATWE adjustment of information in check according to the seismic