型砂（Sand）.docVIP

型砂（Sand） The quality control experience] high density molding sand sand processing system requirements and the quantity of mud and sand temperature and moisture etc., expounds the methods to ensure the quality of molding sand through the detection and Analysis on the properties of molding sand. In recent years, Chinas foundry enterprises especially more and more new foundry enterprises with high pressure molding, air impact molding, injection molding box without high density modeling, modeling process of high starting point, corresponding to the sand quality control requirements are also getting higher and higher. The management of high-density molding sand is very different from that of conventional sand molding, especially for old sand control. The primary task of molding sand quality control is to balance the sand quantity of sand molding system and reduce the fluctuation of sand components. The ideal conditions for sand molding system control shall meet the following conditions: (1) the effective turnover of old sand (or old and new sand) is more than two times as much as that of linear sand. (2) the total amount of sand core flow and the amount of new sand added is less than 3%. (3) old sand crushing and screening system is good, old sand is homogeneous without sand mass. (4) the sand temperature of old sand is not higher than room temperature 15 degrees (summer 40 Celsius). (5) the old sand before mixing sand is kept at 60% ~ 70% of molding sand moisture content. (6) the sand content of old sand (or mixed with old and new sand) is controlled from 7% to 11%. As far as possible to achieve the control of the state, should reduce the overall amount of sand sand processing system fluctuations, pay close attention to the change of casting type, material, sand, iron casting modulus, adjust the formulation in a timely manner through the data on-line detection of sand or laboratory, change of control sand composition, control sand and sand moisture stability. Strictly