smps for whitegoods开关电源培训.ppt

SMPS Power Supply Agenda Basics of AC to DC SMPS NCP1200 current mode controller design NCP1000 voltage mode controller design Basics of DC to DC Converters LM2575 Comparison between Power Bipolar and MOSFET Comparison between different type of Diodes Flyback Converter Selection Guide Forward Converter Selection Guide Push-Pull Converter Selection Guide Snubber and diode selection NCP1200The straight road to power supply design NCP1200 : the fastest way to SMPS design: NCP1200 : SMPS design has never been easier! The Dynamic Self-Supply (DSS) powers the IC NCP1200 fulfills the next IEA recommendations To further reduce the DSS contribution: NCP1200 skips cycles when power demand is low... NCP1200 for noise free operation in standby... Output pulses at various Standby power levels(X = 5 s/div) P1P2P3 Overload operation Overload circuitry protects your design SPICE model speeds-up your design stage SPICE model ensures design stability A 3.5W battery charger application A 3.5W wall adapter application NCP1200 cost advantages: DVD Power Supply 1 DVD Power Supply 2 70W Current Mode SMPS A 10W AC/DC adapter built with the NCP1200 Performance… PCB layout Constant Current Constant Voltage AC Adapter Performance… NCP100X SMPS design MOSFET integrated on chip LM257X series DC/DC design Integrated switch on chip How to select the Diode Additional feature by using On/Off Pin LM2575-5.0 Step-Down Converter Inverting Buck-Boost Regulator(-12V, 0.35A) Handling EMI Switch Mode Power Supply Design The most effective way to handle EMI is to minimize itssource, then use filters to filter away the remaining noise. High dt/dt and di/dt Loop on Primary Side The Drain–to–Source voltage of the transistor, VDS, has a high dv/dt characteristics. the leakage inductance results in voltage spikes and ringing, consequently generating noise. Typically, the collector or drain of the transistor is connected to the tab of the package. (TO–220, TO247 and etc.) The package’s tab becomes a