导线与载流（With the current carrying wire）.docVIP

导线与载流（With the current carrying wire） The wire diameter and the current relationship The relationship between the conductor cross-sectional area and current General safety wire is calculated: 2.5 square mm copper power line of the safe carrying capacity 28A. 4 square mm copper power line of the safe carrying capacity 35A. 6 square mm copper power line of the safe carrying capacity 48A. 10 square mm copper power line of the safe carrying capacity 65A. 16 square mm copper power line of the safe carrying capacity 91A. 25 square mm copper power line of the safe carrying capacity 120A. If it is aluminum wire, wire diameter to 1.5-2 times of the copper wire. If the wire current is less than 28A per square millimeter, 10A to take positive security. If the wire current is greater than 120A, the per square mm 5A to take. The current cross-sectional area of wire can be chosen according to the normal through the total current needed to conduct, can be determined according to the following doggerel: Ten five, two 25354 100, three, seven ten Jiuwuliang half, copper upgrade. Explain to you, is a 10 square aluminum square millimeter, multiplied by the number 5 on it, if it is a copper wire, lifting gear, such as the 2.5 square copper wire, is calculated according to 4 square meters. More than one hundred are multiplied by the cross-sectional area of 2, less than twenty-five square multiplied by 4, more than thirty-five square multiplied by 3, up seven and 95 square are multiplied by 2.5, so a few formulas should be easy to remember, Note: only as an estimate, not very accurate. In addition if the indoor remember less than 6 mm2 copper wire, each square current not exceeding 10A is safe, from this perspective, you can choose 1.5 square 2.5 square copper or aluminum. 10 meters, the wire current density 6A/ mm is more appropriate, 10-50 m, 3A/ mm, 2A/ mm, 50-200 meters, 500 meters to less than 1A/ mm. From this point of view, if not very far from the situation, you can choose 4 or 6