导线的安全电流（Safe current conductor）.docVIP

导线的安全电流（Safe current conductor） The safe current carrying capacity of wire Table 1: ambient temperature under steady-state conditions, the current carrying capacity of the different laying method of PVC insulated copper wire or cable (I) Laying method B1 B E /mm2 sectional area of current carrying capacity (I) A 0.75 - 7.6 1 10.4 9.6 11.7 11.5 1.5 13.5 12.2 16.1 15.2- 2.5 18.3 16.52122 425232830 635293637 1044405052 1660536670 2577678488 359083104114 50 - 123123 70 - 155155 95 - 192192 120 - 221221 Methods: using B1 conduit and cable duct device placement and wire (single core cable). Methods: B1 and B1, but for multi core cable. Methods: no C conduit or cable channel, hanging wall side. Methods: E cable installed in the horizontal or vertical type cable bracket. Table 1 gives the current carrying capacity of the ambient temperature PVC insulated conductor. For the rest of the ambient temperature, the installer should according to the correction factors given in Table 2 the current carrying capacity value. Table 2: correction factor Ambient temperature / C correction coefficient 301.15 351.08 401 450.91 500.82 550.71 600.58 Note: the current carrying capacity parameters and correction coefficient, derived from GB 5226.1-2002/IEC 60204-1:2000 Selection of cable section Source: home electrical: 2011-03-23 reading: 138 Tags: voltage and current cable Estimation method of cable section To estimate the load current 1. use This is based on the power of electrical equipment (kW or kVA) to calculate the current (ANN) formula. The size of the current is directly related to power, voltage, and also dont rate (also known as power factor and so on). The general formula for calculating. Because the factory is used 380/220 volts three-phase four wire system, therefore, can be calculated according to the size of direct current power. 2. formula Low voltage 380/220 Volts CURRENT per kW, anne. KW, current, how to calculate? Electric power is doubled, plus half. 1. Single phase kilow