手机信号维修（Mobile phone signal maintenance）.docVIP

手机信号维修（Mobile phone signal maintenance） Mobile phone network not (no signal) is a common multiple fault (accounting for more than 40% of the mobile phone, mobile phone fault) to appear network (no fault signal) we first distinguish between receiving part or the transmitter The reason causing the clear only after an antidote against the disease. Normally we can be in the mobile phone network settings menu and sub menu, select the search network, enter after the players move and then determine the search network; 1: if you can search to the network (China Mobile and China Unicom China will display on the screen) is a preliminary description of work of the receiving part is often not (no signal), network fault is part of the problem (only significant emission China Mobile or China Unicom one, the mobile phone is not just receiving part path smooth or 13 MHz /VCO with frequency offset, if not part of the normal launch network); II: if you cannot search to the network that mobile phone receiving circuit part of a problem. Preliminary locating faults in repair. Open mobile phone, we can receive power supply boot (do not put cards), to observe the change of the mobile phone search network current and standby current, change the magnitude of the current five seconds within the mobile phone usually boot Relatively large, irregular beating around 100mA (this is part of the mobile phone receiving change into VCO in the receiving state, the frequency of the received frequency of public mobile phone on base station Frequency channel). 1: if the receiving part is working properly, a few seconds after the mobile phone will enter the normal standby current changes regularly in about 5-20mA (about one second swing once, when the mobile phone receiving part) base This is normal; The mobile phone: if the boot current is always irregular changes in about 50-100mA, back to 10-20mA in about ten seconds after a few seconds, and then jump to about 50-100mA, so repeatedly, then received Par