构件截面 估算（The component section estimation）.docVIP

构件截面 估算（The component section estimation） Beam, column and slab cross-section values Beam, column and slab section selection principle A column, in accordance with the code for design of concrete structures GB50010-2002. The minimum edge column size of 300mm, but the high, general frame column section project width not less than 400mm. Two, 1, beam frame beam (1), general 250mm, 300mm wide beam, 350mm (2), high span 1/10-1/13 beam A beam (1) and the width of 200mm, 250mm (2), beam height is 1/10-1/14 Cantilever beam is usually taken as the cantilever length of 1/4~1/6 Common beam height: 250, 300,... 750, 800, 900, 1000. Liang Kuan commonly used are: 120, 150, 180, 200, 220, 250, 300, with 50 of the modulus increasing. Cast structure, general beam should be at least 50mm higher than the secondary beam, such as the lower reinforced double configuration or additional transverse reinforcement by hanging bars, should be higher than 100mm. The economic span: plate: 1.7-2.7m, Main: 5-8m,: 4-6m secondary beam. The beam section size selection principle Number of component types simply supported continuous Multi Span Cantilever show 1 beam ~ Whole cast-in-situ ribbed beams The 2 main girder ~ Whole cast-in-situ ribbed beams 3 independent beam 4 - frame beam The cast-in-place frame beam 5 - frame beam Integral assembly or assembly type frame beam 6 flat beam frame ~ Cast-in-situ monolithic reinforced concrete flat beam frame 7 flat beam frame ~ The prestressed concrete flat beam frame Three, plate Under common loads, thickness of about 1/36-1/45 across the board, but not less than 100mm (individual rooms should not less than 80mm). The minimum plate height span ratio The type of bearing plate of the form Single plate two-way slab cantilever plate beamless floor 1/35 1/45 1/35 (simply supported column run) 1/40 1/50 1/12 1/30 (continuous column free run) Note: the plate thickness / short side direction calculation of span The beam and column section size and material from the