LVDS Serdes 48 EVM Kit Setup And Usage （LVDS并行转换器48维生素与设备安装和使用）.pdf

Application Report SLLA043 LVDS Serdes 48 EVM Kit Setup and Usage Boyd Barrie and Dung Nguyen Mixed Signal DSP Solutions Abstract This document describes the Texas Instruments (TI™) LVDS Serdes 48 evaluation module (EVM) kit. The LVDS Serdes 48 EVM kit is used to evaluate and design high data throughput prototypes using the TI LVDS95 transmitter and LVDS96 receiver boards. The boards allow the designer to connect 21 bits of data and clock to the transmitter board where LVDS technology is available to serialize and transmit the data along four differential pairs (three data and one clock). The receiver board then deserializes the data, providing 21 bits of 3.3 V TTL data and clock. The transmitter and receiver boards can be used to evaluate device parameters while acting as a guide for high-speed board layout. The high-speed LVDS interface uses a 50 W controlled- impedance parallel cable available in various lengths. The low-speed interface uses a standard 50 pin parallel ribbon cable. Overall, the designer can use the EVM kit as a tool for successful evaluation and design of an end product. Contents Introduction 2 LVDS Serdes 48 EVM Kit Contents 3 LVDS Serdes 48 EVM Boards Configuration3 Typical Test and Setup Configuration 5 Test Results 5 PCB Transmission Line Characteristics9 Layer Construction for Transmitter/Receiver Boards 11 Appendix A. Schematics, Board Layouts, and MDR Cable Assembly Specifications 11 Digital Signal Processing Solutions March 1999 Application Report SLLA043