SPECIFICATION STANDARD GROUNDING AND （规范标准接地和）.pdf

SPECIFICATION STANDARD GROUNDING AND BONDING 27 05 26 PART 1: GENERAL 1.01 SCOPE OF WORK A. The grounding and bonding system refers to all electrodes required by NEC, as well as including made, supplementary, information technology and telecommunications system grounding electrodes B. Provide all labor, materials, tools, installation equipment, and test equipment required for the complete installation of grounding and bonding for fore mentioned systems within the structure. C. The Design Team and/or Contractor are held responsible to be familiar with the provisions contained herein and with other Sections of this Specification as applicable to the completion of the installation. The approved vendor, designated agent or employee is responsible to be familiar with the provisions contained herein and is assumed to posses the knowledge, manpower, and material applicable to completion of the installation. D. Work covered by this Section shall consist of furnishing labor, equipment, supplies, materials, and testing otherwise specified, and in performing the following operations recognized as necessary for the installation, termination, and labeling of ground and bonding infrastructure as described on the Drawing and /or required by these specifications. E. Listed manufacturers and products are required. UNM IT approved equivalent products and systems are also acceptable with prior written approval of submittals by UNM IT. F. The telecommunications main grounding bar (TMGB) is a dedicated extension of the building grounding electrode system for the telecommunications system. The TMGB should be located near the telecommunications service entrance and the electric service entrance. G. The TMGB shall be located to minimize the length of the bon