arm启动流程（Arm startup process）.docVIP

arm启动流程（Arm startup process） Understanding barriers generally appear are in the start and start process of the two words. Here we will explain this problem step by step two. Our program is generally divided into two parts: the startup code and function code, the main work boot code is various working modes under the chip initialization stack (if you need to use the interrupt, the interrupt vector table, also define) generally consists of chip design engineer in assembler language, of course, different chips this program will be after different, basically no change, so very refined, embedded engineers can be directly used, then the default CPU program pointer jump to __main () function, here to initialize some data areas like, below is our usual jump to the preparation of the main () function, which is also called function code. The code on the chip before power save where? ARM chip power is from the default address start executing the program, but this address is ESRAM or SDRAM, the two memory is non-volatile memory storage, code no power function, that is to say that there is uncertainty value when we chip power up to ESRAM (all 0 for DDR, random value), the code to be executed in where? It leads to the concept of the start! ARM generally have internal and external memory chip Flash start start (NAND, NOR, SD) started two ways: 1, the internal Flash Start refers to PC after power on chip memory in the immediate implementation of this code, note here is not zero. But the memory capacity is very small, because the cost of the chip size and an exponential relationship, then it is not possible to code we write them in it, so just be saved to the Flash boot code chip, the function of the code is stored in the external memory capacity of cheap, so start code is another work: from the external memory handling function code can execute code to a memory (such as NOR, SDRAM, ESRAM), and then jumps to the address to execute the function code. 2, external memory start generall