otis 维修案例（奥的斯维修案例）.docVIP

otis 维修案例（奥的斯维修案例） Xizi Otis XIZIOTIS elevator maintenance -- Xizi Otis XIZIOTIS FB-HLAN[BO] motherboard GVF-III motherboard repair call board motherboard GHE-FMT NPH and GVF-2 universal display panel call sclc-v1.1 communication board NPH-2-SCLB V1.0 driver board INV-BDCC3 switching power supply board EL3-AVR01 board DMC-1 board door door DMD-1 relay board RYBD board FB-MPU (BO) FBDMC (B2) gate board circuit board SDC display board FB-HLAN (BO) FB-IGD (BO) inverter drive plate Xizi Otis XIZIOTISNPX door board maintenance, SDC car top communication board maintenance (Xizi Otis XIZIOTIS elevator parts maintenance) ? fault 1 3100 user complaints elevator cant stop operation, call does not work, the floor display is normal, do not open the door. TT check the TCB fault record 0100, 0105, OVF20 CHK DBD SIG fault record, check SW1, 2 relay, SW1 relay assisted bad contact, after the replacement of normal. Fault 2 T60 elevator user complaints in the flat position repeatedly open and close, need to close several times before running, most of the time normal. Check the MIB board and frequency converter without fault recording. Observe in the computer room, wait for the breakdown to appear. Found in the presence of failure U, D relay immediately after the break, check with a multimeter U, D relay A1 voltage, there is no voltage at the time of the fault with fault fault free registration, suspected fault should be in the security checkpoint after checking the car door, hall door contact normal, temporarily not check out the point of failure, and to observe the operation, found in LB after U, the relay D relay will be disconnected, check the drawings, LB relay basically had no effect on U, D relay. Then hold the LB relay by hand and make it artificially controlled, and the fault is not found. Suspected LB relay fault, will control the relay contact the main cabinet check, found that 13-14 SDP 50-200 relay contact resistance in ohms, the contact fault frequency was significantly