几起皮带伤人事故（Several belt injuries）.docVIP

几起皮带伤人事故（Several belt injuries） Case 1: an accident about GEs illegal operation Around 17:30 p.m. on November 6, 2007, a staff member of alumina two companys workshop cleaned the belt at No. 7 furnace 1, causing the right arm to be involved in the belt, resulting in a fracture of the right forearm. Accident cause analysis Direct reason: I am accustomed to illegal operation, cleaning equipment is rotating. , Indirect reasons: the staffs job monitoring is not in place, and the safety of typical accidents is not enough. Two, accident prevention and rectification measures 1, require scheduling meeting, all classes will work before the safety, improve safety awareness. 2, strengthen staff safety education and similar cases of learning, improve safety awareness. 3, strengthen the supervision of dangerous workers in the process of independent work. 4, strictly prohibit the operation of the equipment to do any clean-up work. Case two: about the illegal operation of Liu At 20:20 on October 10, 2007 or so, the two plant material Workshop 12 belt in the transport of ore, due to ore viscosity, resulting in 12 belt pulley roller scar. The shift operator Liu did not stop in the belt belt case, screw steel half meter long cleaning support accumulated material roll, steel roller accidentally involved with scraper, the left hand is taken, causing his left ring finger is rubbed a piece of skin. I. causes of accidents Through detailed understanding of the accident and careful investigation of the accident site, the cause of the accident is as follows: 1, in the case of belt conveyor running, illegal use of thread steel cleaning operations, is the direct cause of the accident; 2, staff awareness of security is weak, self-protection ability is poor; Workshop safety education is not in place, the past belt crush notification learning is not deep enough, inadequate attention to safety work; 3, the driving wheel at the accident site, driven wheel set at the running equipment, attention to