GCC写的AT24C64接口程序.docVIP

GCC写的AT24C64接口程序 关于ATMEGA的TWI编程的。  // AT24C64 support functions using ATMEGAs TWI // pin-WP is hard-wired to GND // fuctions work better outside interrupt routines // by MXH, 2003/07/30 #include DStruct.h #include avr/twi.h // CONSTANTS DEFINITION FOR EEPROM #define EEADDR 0 #define EEWR 0 #define EERD 1 // TWINT *NOT* set after STOP condition is sent // check status? // TWSTO is cleared by hardware #define TwiStop() TWCR = _BV(TWINT) | _BV(TWEN) | _BV(TWSTO) #define TwiStart() TWCR = _BV(TWINT) | _BV(TWEN) | _BV(TWSTA) #define TWI_STATUS (TWSR 0xF8) BYTE byEEWait; ////////////////////////////////////////////////////////////////////////// // implementation BOOL EEPStart(BYTE addr, BOOL bWrite) { byEEWait = 10; // 90~100ms poll_ack: TwiStart(); while (!(TWCR (1TWINT))){ // wait if ( byEEWait == 0 ){ return FALSE; } } if ((TWI_STATUS != TW_START)(TWI_STATUS != TW_REP_START)) goto poll_ack; //byEEWait = 3; // 20~30ms // send SLA+R/W TWDR = addr | bWrite; TWCR = (1TWINT)|(1TWEN); while (!(TWCR (1TWINT))){ if( byEEWait == 0 ){ TwiStop(); return FALSE; } } if( EEWR == bWrite ){ // MT mode //if(TWI_STATUS != TW_MT_SLA_ACK) switch(TWI_STATUS){ case TW_MT_SLA_ACK: break; case TW_MT_SLA_NACK: goto poll_ack; default: TwiStop(); return FALSE; } }else{ // MR mode if(TWI_STATUS != TW_MR_SLA_ACK) return FALSE; } return TRUE; } ////////////////////////////////////////////////////////////////////// //  BYTE EEPWrite( WORD uiAddress, WORD uiLen, void *pBuf ) //using 0 { unsigned int i,j,uiCnt;  if( uiLen == 0 ) return 0; uiCnt = 0; // uiEnd = uiAddress +