松下彩电mx-4机芯开关电源的原理及检修思路（Principle and maintenance thinking of Panasonic mx-4 switch power supply）.docVIP

下载本文档

11
0
约8.26千字
约 6页
2017-10-13 发布于河南
举报
版权申诉

松下彩电mx-4机芯开关电源的原理及检修思路（Principle and maintenance thinking of Panasonic mx-4 switch power supply）.doc

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
7、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

松下彩电mx-4机芯开关电源的原理及检修思路（Principle and maintenance thinking of Panasonic mx-4 switch power supply）

松下彩电mx-4机芯开关电源的原理及检修思路（Principle and maintenance thinking of Panasonic mx-4 switch power supply） The power supply for the parallel switching power supply, the self-excited PWM circuit, the output and the grid isolation (commonly known as cold plate), a total of 1.40V, 22V, 15V, 8V four groups of output voltage, the standby voltage generated by the same switching transformer, its working principle is as follows: Rectifier and filter circuit The C801, C802, C803, L801 and L802 compose the power grid filter, which is used to weaken the interference clutter of the power supply, and prevent the interference of the power supply from polluting the power grid. The power supply goes through the filter and goes all the way to the automatic degaussing circuit, all the way through the D803 bridge rectifier, and the output of the 310V pulsating DC power supply is supplied by the C817 filter. Reprinted, please note from the maintenance, - Two, start and oscillation process 310V power supply voltage by switching transformer T801 2 - 4. To switch the collector of Q801, at the same time, 310V R814, R815 voltage through the startup resistor, R816 step-down current limiting added to the base of Q801, the Q801 is switched on, the collector current through the primary coil - the excitation coil is coupled to the 6 - 7, 6 - 7 induced across the polarity is under negative voltage, the collector current Q801. Thus, this is a positive feedback process, and Q801 quickly enters saturation and stores magnetic energy in the T801. Q801 once saturated. Change the collector current rate decreases rapidly, and the induction voltage - winding will decrease rapidly, positive feedback weakened, the Q801 by the exit and enter the saturation amplification, then the voltage - and winding polarity reversal, through positive feedback, make Q801 and cut-off quickly, so the oscillation. At the cut-off of Q801, the positive, negative and negative induced voltages are induced on the secondary windings of the T