电机功率计算（Motor power calculation）.docVIP

电机功率计算（Motor power calculation） First, the difference between motor power rating and actual power In this data, the motor is in the best working condition. The rated voltage is fixed, allowing deviation 10%. The actual power and actual current of the motor vary with the magnitude of the drag load; When the load is large, the actual power and actual current are large; When the load is small, the actual power and the actual current are small. The actual power and actual current are greater than the rated power and rated current, and the motor will overheat and burn down; Actual power and actual current are less than rated power and rated current, resulting in waste of materials. Their relationship is: Rated power = rated current IN*, rated voltage UN* root 3* power factor Actual power = actual current IN* actual voltage UN* root 3* power factor Two, 280KW pump motor rated current and starting current calculation formula and the corresponding specifications (1) the current of the 280KW motor is related to the number of poles and the power factor. The general formula is: current = ((280KW/380V) /1.73) /0.8.5=501A (2) the starting current is 7 times of the rated current if it is started directly. (3) decompression start is based on tap of frequency sensitive rheostat. BP4-300WK frequency sensitive rheostat is used, the starting current of the device is 2.4 times of the rated value. Three, for example, how about the rated current of a 37KW wound motor? Current rated power / voltage V = 3* * power factor ? 1, P = 3 * * U * I * COS; ??????? 2, I = P/ * U * 3 * COS; ??????? 3.?? I=? 37000/ 3 x 380 x 0.82 V Four. The calculation formula of motor power Calculation formula Three phase two hundred and twenty motors, kW three point five amperes. Three phase three hundred and eighty motors, one kW, two amperes. Three phase six hundred and sixty motors, kW one point two amperes. Three phase three thousand volt motor, four kW ampere. Three phase six thousand volt motor, eight kW amp