内存不能read（Memory cannot be read）.docVIP

内存不能read（Memory cannot be read） Memory cannot be a solution for read or written This memory cannot be a solution for read or written People who use the Windows operating system sometimes experience such error messages: 0X??. The directive refers to the 0memory that cannot be read or written , and then the application is closed. If you ask some experts, the answer is often Windows is so unstable and so on. In fact, this error is not necessarily caused by Windows instability. This paper briefly analyzes the common causes of such mistakes. First, the application failed to check the memory allocation failure The program requires a memory to store data, you need to use the operating system to provide the function to apply, if successful memory allocation, memory area function will be the new return to the application, the application can use this memory via this address. This is called dynamic memory allocation, the memory address, that is, the cursor in programming. Memory is not always available, endless, and sometimes memory allocation will fail. When the allocation fails, the system function returns a 0 value, when the return value 0 does not represent the newly enabled cursor, but rather a notification issued by the system to the application informing the error. As an application, in the memory after each application should check whether the return value is 0, if it is, it means that there is a fault, some measures should be taken to save, which enhances the robustness of the program. If the application does not check the error, it will continue to use this memory in subsequent execution, in accordance with the idea that the value is the available cursor allocated to it. The real 0 address memory area stores the most important interrupt descriptor table in the computer system and absolutely does not allow the application to use it. In the operating system without protection mechanism under (such as DOS), write data to this address will lead to crash immed