论外文翻译论文范文.docVIP

　　论外文翻译论文范文 论外文翻译论文范文 导读：ming.ThesoftaybeobtainedbydoAtmel’s.GeneralConsiderationsEA/VPPmustbeheldhighduringprogramming.Inapplicationsmemory,thispinmaybepermanentlystrappedtoVCC.Applicationsutilizingexternalprogram 附附录 A 外文资料 录 AT89C51 In-Circuit ProgrammingThis application note illustrates the in-circuit programmability of the Atmel AT89C51 Flash-based microcontroller. Guidelines for the addition of in-circuit programmability to AT89C51 applications are presented along ple and the modifications to it required to support in-circuit programming. A method is then shoicrocontroller in the application can be reprogrammed remoy, over a mercial ephone line. The circuitry described in this application note supports five volt programming only, requiring the use of an AT89C51-XX-5. The standard AT89C51 requires 12 volts for programming. The softay be obtained by do Atmel’s. General Considerations EA/VPP must be held high during programming. In applications memory, this pin may be permanently strapped to VCC. Applications utilizing external program memory require that this pin be held loal operation. RST must be held active during programming. A means must be provided for overriding the application reset circuit, which typically asserts RST only briefly after powe 3 4 5 6 7 8 9 10 论外文翻译论文范文 导读：ming,butmustnotbedrivenduringnormaloperation.ALE/PROGispulsedloming,butmustnotbedrivenduringnormaloperation.Duringprogramming,AT89C51I/Oportsareusedfortheapplicationofmodeselect,addressesanddata,possiblyrequiringthatthecontrollerbeisolatedf r is applied. PSEN must be held loming, but must not be driven during normal operation. ALE/PROG is pulsed loming, but must not be driven during normal operation. During programming, AT89C51 I/O ports are used for the application of mode select, addresses and data, possibly requiring that the controller be isolated from the application circuitry. Hos. Port Used for Input During programming, the controller must be isolated from signals sourced by