试论外文翻译1论文范文.docVIP

　　试论外文翻译1论文范文 试论外文翻译1论文范文 导读：ismillingmachineandaCsystemillingmachine.The3-axismillingmachinehasamini-desktopsizeof200×300×200mm3anditscuttingvolumeis20×20×20mm3.TheverticallyinstalledXYstageisdrivenbyvoice-coilmotors,andforthez-axis,amagical 好多学校 毕业设计的时候 会让大家翻译一篇外文论文 那好吧 下载即可Development of a 3-axis Desktop Milling Machine and a C System Using Advanced Modern Control AlgorithmsByung-Sub Kim ， Seung-Kook Ro and Jong-Ks Research Division, Korea Institute of Machinery Materials, Daejeon, South Korea, 305-343 Corresponding Author / E-mail: bkimkimm.re.kr, TEL: +82-42-868-7109, FAX: +82-42-868-7180 In this paper, illing machine and a C system illing machine. The 3-axis milling machine has a mini-desktop size of 200×300×200 mm3 and its cutting volume is 20×20×20 mm3. The vertically installed XY stage is driven by voice-coil motors, and for the z-axis, a magically preloaded air bearing and a linear motor are used. The air spindle runs at up to 160,000 rpm. The gravity force is acting on the y-direction, so a designed for the 3-axis milling machine consists of t icrosof 3 4 5 6 7 8 9 10 试论外文翻译1论文范文 导读：-codesinreal-time.ToimprovetheperformanceofservocontrolloopintheCsystembeyondthetraditionalPID-typecontrol,severalmoderncontrolalgorithmshavebeentestedincludingcontrol,inputshapingcontrol,disturbanceobserverandcross-coupledcontrolonthe3-axismillingmachine.E t ented on a DSP board e. To improve the performance of servo control loop in the C system beyond the traditional PID-type control, several modern control algorithms have been tested including control, input shaping control, disturbance observer and cross-coupled control on the 3-axis milling machine. Experimental results shoe illing machine. KEYilling machine, C system, H control, Input shaper, Cross-coupled control1 1. IntroductionAs neation Technology), BT(Bio Technology) and NT(Nano Technology) emerge as a driving force in the industry, the interests in micro-factory system have been groicro-factory is a mi