试述发动机曲柄的论文.docVIP

　　试述发动机曲柄的论文 试述发动机曲柄的论文 导读：及夹具分别进行了讨论，计算各道工序的切削用量等加工参数及机动和辅助工时。第三，对加工所用夹具进行了举例，以及定位元件、夹紧机构的选取，定位分析与误差的计算，夹紧力的确定做了必要的阐述。第四，介绍了应用三维软件pro/e进行零件造型的过程及夹具设计过程。关键字：曲轴夹具加工Pro/eTheCraftp (Turning Frock) Abstract The planning the machining process and gripping device of turning connecting lever for the crank-shaft of the motor is introduced. The modernized machining methods and sophisticated equipments are led into the machining process, base on the conventional machining process engineering. In the place of the bined machine tools, bined cutting tool is used to improve productivity and ensure the location accuracy of the feature, the production cost is reduced and the adjustment of production is facilitated. The thesis will discuss the con 3 4 5 6 7 8 9 10 试述发动机曲柄的论文 导读：nedaboveasfolloachiningprocessislaiddoachiningprocess.Secondly,thechoiceofthemachinetools,themeasuringimplement,thefixture,andth tent mentioned above as folloachining process is laid doachining process. Secondly, the choice of the machine tools, the measuring implement, the fixture, and the cutting tool of the stages in manufacturing is discussed after the technical analysis of every process step and machining parameters is puted, and the machining time and the auxiliary time are also calculated in this section. Thirdly, the example of special fixture design is introduced, as ination of the clamping force. Fourthly, in this part, ensional softake the 3D modeling of the part and gripping device. Keyanufacture, Pro/e 目 录 1 引言 ................................................................................................................................ 1 2 概述 ................................................................................................................................ 2 2.1工艺 3 4 5 6 7 8 9 10 试述发动机曲柄的论文 导读：.......................54工艺路线的拟定.............................................................................................................74.1选择定位基准......................