电器盒座注射模大学设计.docVIP

【摘　　要】 本毕业设计内容是电器盒座的模具设计，通过对塑件进行工艺性分析和比较，最终设计出一副注塑模。该毕业设计从产品结构工艺性，具体模具结构出发，对模具的浇注系统、模具成型部分的结构、顶出系统、冷却系统、注塑机的选择及有关参数校核，都有详细的设计，塑料注射成型的最大特点是成形周期短，能一次成型复杂、尺寸精密等塑料工件，对各种塑料的适应性强，生产效率高，产品质量稳定，易于实现自动化生产。注射成型的过程是把塑料原料放入料筒中经过加热熔融塑化成为黏流态的液体，在柱塞或螺杆的高压推动下，使熔体通过喷嘴以较高压力注入模具的型腔中，经过冷却、凝固阶段，冷却定型后，然后开模分型的成形塑件，得到塑件制品。设计中主要进行的工作首先是对塑料进行工艺性能的分析并画出零件图，在这次设计中，要用到侧抽芯，所以要进行侧抽芯机构(斜导柱和滑块)的设计，以及主、分流道的设计、模具型腔的分布并要画出它们的零件图，模架的选择和校核、注塑机的选取和校核等，最重要的一部分是对模具结构中型腔、型芯各径向和高度尺寸的计算过程，这些的设计过程要查阅大量的资料，并要对模具进行装配和试模，对其中出现的问题对模具进行改进，直到最后的零件符合设计要求。 【关键词】：电器盒座，注射模具 Abstract The contents of this graduation project is the electrical box seat mold design, plastic parts through the process of analysis and comparison, the final design of an injection mold. The graduation process from the product structure of the specific structure of the starting mold of the casting mold system, mold forming part of the structure, the top of the system, cooling system, the choice of injection molding machines and checking the parameters, there are detailed design, plastic Injection molding cycle, the maximum is characterized by short, to forming a complex, precise dimensions, such as plastic parts, the adaptability of various plastics, high production efficiency, product quality is stable, easy to automate production. The process of injection molding of plastic materials is to melt into the barrel through the viscous flow of plastics into liquid, high pressure in the plunger or screw driven, the higher the melt through the nozzle into the mold cavity pressure After cooling, the solidification stage, the cooling is formed, and then typing into a mold shaped pieces are plastic parts products. Mainly for the design work is the first analysis of process performance plastics and draw parts diagram, in this design, the use to the side core pulling, so the side core pulling (angle pin and slide) and design, and the Lord, shunt design, the distribution of the mold cavity and to draw part of their plans, the selection and verification mold,