Development of a Cold Model for Burden Distribution at Bell-less Top of Blast Furnace论文.pdfVIP

Development of a Cold Model for Burden Distribution at Bell-less Top of Blast Furnace ·1 · Development of a Cold Model for Burden Distribution at Bell-less Top of Blast Furnace 1 1 1 1 1 2 Zhao Huatao , Du Ping , Ren Liqun , Liu Jianbo , Tang Manfa (1. Ironmaking Environment Research Group, Institute of Research of Iron Steel, Shasteel, Jinfeng, Zhangjiagang 215625, China; 2. Hongfa Ironmaking Plant, Shasteel, Jinfeng, Zhangjiagang, 215625, China) Abstract The burden profile distribution in the radial direction of the blast furnace determines the gas flow passage, thus it is of vital importance for stable and economical operation of a blast furnace. In this study, an experimental bell-less top charging 3 : blast furnace in Shasteel to investigate how burden layer behaves inside the large model was built on a 1 15 scale of 5800m scale blast furnace. To keep the same similarity condition between the cold charging model and the actual blast furnace, the particle size distribution, burden falling trajectory, and the U/Umf were kept the same. Automatic charging of materials into the cold model is done by a rotating distributor at preset charging and blowing parameters which are determined by similarity condition. By making use of this model furnace, the burden layer distribution in the radial direction of 5800m3 at four stable operation periods was reproduced. The result shows that with increase of center coke amount, the slope angle decreases and less coke is pushed to the center part of blast furnace, while large amount of center coke le