WCDMA RNC Commission (Rel .RAS06)XYH（诺西RNC开原版英文资料）.docVIP

Commissioning Refer to following table for IP information needed to make connection between PC and RNC Preconfigured IP settings IP addresses Mask Default gateway OMU 40 NEMUOMS 40 ESA24 40 DHCP server pool (for Element Manager) 0 40 Devices and tools for commissioning: Wristband, Digital Multimeter, M2.5 allen key (内六角扳手), RS232-cable (RJ45 to 9-pol female) – 2 pcs, RS232 interface (9-pol male). Computer with terminal application and NED. Inspecting Hardware Inspect the cabling There are three following types of cable: Intrasubrack cables Intracabinet cables Intercabinet cables Intrasubrack cables and intracabinet cables are installed at the factory. However, Intercabinet cables have to be installed at site according to the Cable list in site documentation Inspect the location of plug-in units Refer to Equipment Lists in site documentation Position The slots are denoted with numbers F01-F19 in order from left to right, plus number F38 for the half-height slot below slot F19, on the far right. ID C number Name abbreviated name of the plug-in unit FU functional unit name and index number for the plug-in unit Inspect the interchangeability versions of subracks and plug-in units Refer to RNC HW Revision list in site documentation. The interchangeability version of a plug-in units is written in the sticker right after the C number. Inspect jumper settings Overview Most of the plug-in units do not require any alteration of their factory jumper settings. The plug-in units in the following table require specific jumper settings which may have to be modified by the customer: Plug-in unit Jumper block Note CCPC2-A J16 If unit is used as OMU, default settings have to be modified HDS CN2 Factory settings may have to be modified HDS9 CN2 Factory settings may have to be modified HDS-A CN2 Factory settings may have to be modified HDS-B CN2 Factory settings may have to be modified MDS-A, MDS-B Jumpers and DIP switches Factory settings m