ASME标准磁粉探伤规程.doc

ASME标准磁粉检测通用工艺规程 POE0702-CAL-ST-01 Calculation For In-Place Strength Analysis For Submarine Pipelines Rev. B Employer : SONILS LDA Engineer : SCOTT WILSON LTD, UK Contractor : CHINA HARBOUR ENGINEERING CO., LTD. Subcontractor: PETRO-OFFSHORE ENGINEERING Issue Status B 30May07 App. A 16Feb07 Draft SQF AXH SSW Rev. Date Description Prep’d Chk’d App’d ICE REF. CONTENTS 1. General 3 2. Personnel 3 3. Description of Method 3 4. Magnetization Equipment and Calibration 3 5. Examination Medium 4 6. Magnetization Procedure 5 7. Magnetic Field Strength 5 8. Examination Requirements 5  1. General 1.1 This procedure is applied to the magnetic particle examination of ferromagnetic materials and welds for ASME Code items. 1.2 The magnetic particle examination method is suitable for detecting cracks and other discontinuities on or near the surface in ferromagnetic materials. 1.3 This procedure is applied to wet continuous magnetization by yoke, which shall only be applied to detect discontinuities that are open to the surface of the part. 1.4 This procedure shall be demonstrated to the satisfaction of the AI prior to implementation. 2. Personnel 2.1 The NDE personnel who engage in magnetic particle examination shall be qualified and certified according to NJBST Co.,Ltd.’s “Written Practice for NDE Personnel Training, Examination, Qualification Certification”(No.:QCD-011). 3. Description of Method 3.1 In principle, the magnetic particle examination method involves magnetizing an area to be examined, and applying ferromagnetic particles to the surface. The particles will form patterms on the surface where cracks or other discontinuties cause distortions in the normal magnetic field. These patterns are usually characteristic of the type of discontinuity that is detected. 3.2 The sensitivity of the magnetic particle examination is greatest for surface discontinuities and diminishes rapidly with increasing depth of discontinuities below the surface.