GPP的系统变量表.doc

变量名? ?变量说明? ?数据类型? ?所应用的模块位子 ??ABS_ANG??Start angle + Delta angle??2??CIRCULAR MOTION: ARC_ANG??Arc angle??2??CIRCULAR MOTION: AXIS_ANGLE??Tool axis angle??2??TOOL CHANGE: AXIS_NUM??Number of axes being used??6??AXIS CHANGE:BEGINNING OF TAPE: BLOCK_NUM??Current block number as appears in the TP_LIST??6??All Blocks CIR_INTERP??Circular interpolation mode? ?7??ORIGIN CHANGE CIRC_MOV??Circular movement code??0??CIRCULAR MOTION: CLEAR_LENG??Distance between holder [$ tool tipnbsp] 1??TOOL CHANGE: COMP_3X??3-D cutter compensation??7??LINEAR MOTION: CURR_NAME??Current tool holder name??0??TOOL CHANGE: CURR_ORIG??Controller/Cimatron origin no.??7??ORIGIN CHANGE: BEGINNING OF TAPE: CURR_START??Number of current start??7??START THREAD: CURR_TOOL??Current tool holder number??7??TOOL CHANGE: CUT_LENGTH??Length of cutting edge of tool??1??TOOL CHANGE: CUT_SPEED??Velocity of cutting (Vc)??1??CONSTANT SPEED: CUT_WIDTH??Width of the tool??1??TOOL CHANGE: CUTCOM_OFF??Cutter Compensation off code??0??CUTTER COMPENSATION: CUTCOM_ON??Cutter Compensation on code? ?0??CUTTER COMPENSATION: CYC_2PLN??Not in use.??1??CYCLE: CYC_CLEAR??Cycle clear height??1??CYCLE: CYC_CODE??Cycle code??0??CYCLE: CYC_DEPTH??Cycle depth increment??1??CYCLE: GROOVE CYCLE: CYC_DWELL??Cycle dwell time??5??CYCLE: CYC_DZINIT??The DRILL procedure DEL INIT value??1??CYCLE: CYC_PECK??Cycle PECK value??1??CYCLE: GROOVE CYCLE: CYC_REDUC??Cycle DECREASE value??1??CYCLE: GROOVE CYCLE: CYC_RETR??Cycle retract code??0??CYCLE: CYC_TIMES??Number of pecks/cycle??7??CYCLE: CYC_XSHFT??Cycle shift along the X axis??1??CYCLE: CYC_YSHFT??Cycle shift along the Y axis??1??CYCLE: CYCLE_1??Spot Drill??7??CYCLE: CYCLE_2??High Speed Peck??7??CYCLE: CYCLE_3??Left Hand Tapping??7??CYCLE: CYCLE_4??Fine Boring? ?7??CYCLE: CYCLE_5??Counter Boring??7??CYCLE: CYCLE_6??Deep Hole Peck??7??CYCLE: CYCLE_7??Tapping??7??CYCLE: CYCLE_8??Boring??7??CYCLE: CYCLE_9??Bore + Spindle Stop? ?7??CYCLE: CYCLE_10??Back