IP Phone的QoS.docxVIP

（以下均资料来自权威Cisco官方手册。Writed by liucheng749，转载请注明出处与作者。参考资料：Catalyst 3550软件配置手册、Catalyst 6500软件配置手册等）一、解释是这样的，Use the switchport priority extend interface configuration command to set a port priority for the incoming untagged frames or the priority of frames received by the IP phone connected to the specified port.Use the no form of this command to return to the default setting.翻译：通过使用swichport priority extend的接口配置命令来做下面这两件事，1是为入站未打tag的帧设置一个接口priority值；2是设置通过连接到IP phone的指定端口接收的帧的prioriy值。使用no命令返回到默认设置。switchport priority extend {cos value | trust}no switchport priority extend二、语法，cos value：Set the IP phone port to override the priority received from the PC or the attached device. The class of service (CoS) value is a number from 0 to 7. Seven is the highest priority. The default is 0.翻译：设置IP phone端口不考虑从PC（或其他附着设备）收到的priorty值。COS值是一个0到7的数，最高的priorty是7，默认是0。trust： Set the IP phone port to trust the priority received from the PC or the attached device.翻译：设置IP phone端口信任从PC（或其他附着设备）收到的priorty值三、默认，The port priority is not set, and the default value for untagged frames received on the port is 0. The IP phone connected to the port is set to not trust the priority of incoming traffic and overrides the priority with the CoS value of 0.翻译：默认情况下，端口priority没有设置，并且从端口收到的未打tag的帧的默认值是0；连接到IP Phone的端口设置不信任入站流量的priority，并且也不考虑COS为的0的priority。四、命令模式，Interface configuration 五、使用guideline，In Cisco IOS Release 12.1(13)EA1 or later, the trust keyword replaces the none keyword. To instruct the IP Phone to not trust the priority, you can use the no switchport priority extend or the switchport priority extend cos 0 interface configuration command. In software releases earlier than Cisco IOS Release 12.1(13)EA1, use the switchport priority extend none interface configuration command.翻译：在12.1EA1或更新的版本，关键字“trust”取代了“none”。为了指示IP phone不信任priority，你可以使用 no switchport priority extend或者the switchport priority extend cos 0的接口命令。在发布版软件12.1EA1更早的版本里，使用的是switchport priority extend none的接口命令。When configu