DHCP加生成树加单臂路由.docVIP

拓扑图 我们的目的是配S1 为VTP 的 SERVER模式 ，S1当DHCP 服务器，并把S1做为vlan10根交换机，并做单臂路由使VLAN10与VLAN20 互通。所有交换机的端口5-10 划分到vlan 10 中，11-20 划分到vlan 20 中。 思科交换机默认生成树协议是开启状态。 从图中可以得知S3为根交换机。 S1 S1#show spanning-tree VLAN0001 Spanning tree enabled protocol ieee Root ID Priority 32769 Address 0004.9A36.AE85 // 网桥MAC Cost 19 Port 4(FastEthernet0/4) Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec Bridge ID Priority 32769 (priority 32768 sys-id-ext 1) Address 000B.BE4E.33DC //// 本交换机MAC Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec Aging Time 20 S2 S2#show spanning-tree VLAN0001 Spanning tree enabled protocol ieee Root ID Priority 32769 Address 0004.9A36.AE85 Cost 19 Port 24(FastEthernet0/24) Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec Bridge ID Priority 32769 (priority 32768 sys-id-ext 1) Address 0010.11A8.06B1 Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec Aging Time 20 S3 S3#show spanning-tree VLAN0001 Spanning tree enabled protocol ieee Root ID Priority 32769 Address 0004.9A36.AE85 This bridge is the root Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec Bridge ID Priority 32769 (priority 32768 sys-id-ext 1) Address 0004.9A36.AE85 Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec Aging Time 20 S1 配置 S1(config)#int range f0/1-4 // 进入多端口配置模式 S1(config-if-range)#switchport mode trunk // 把端口改为trunk 模式 S1(config)#int f0/24 // 进入端口配置模式 S1(config-if)# switchport mode trunk // 改为trunk模式 S1#vlan database // 进入VLAN配置配置模式 S1(vlan)#vtp server S1(vlan)#vtp domain only5 // 设置域名为only5 Changing VTP domain name from NULL to