老触摸屏按钮功能说明.docVIP

左模启模：左热压上模上升，制品附在左热上模。 LTM clamp (The left mold goes up): the left hot press upper mold goes up, and the product is sucked on the upper mold; 左模右移：左热压下模右移到位，等待湿胚转移。 LBM R-move (The left mold moves rightwards): the left hot press lower mold moves rightwards to the required position waiting for the wet blank transfer; 右模启模：右热压上模上升，制品附在右热上模。 RTM open (The right mold goes up): the right hot press upper mold goes up, and the product is sucked on the upper mol9d; 右模左移：右热压下模左移到位，等待湿胚转移。 RBM L-move (The right mold moves leftwards): the right hot press lower mold moves leftwards to the required position waiting for the wet blank transfer; 左模合模：左热压上模下降，锁模，压干制品。 LTM clamp (The left mold goes down): the left hot press upper mold goes down, locks themold and presses the dry product; 左模左移：左热压下模左移，返回到位。 LBM return (The left mold returns): the left hot press lower mold moves leftwards and returns to the required position; 右模合模：右热压上模下降，锁模，压干制品。 RTM clamp (The right mold goes down): the right hot press upper mold goes down, locks the mold and presses the dry product; 右模右移：右热压下模右移，返回到位。 RBM return (The right mold returns): the right hot press lower mold moves rightwards and returns to the required position; 冷压合模：冷压上模下降到吸滤模，冷压湿胚。 CTM clamp(Cold press down): the cold press upper mold goes down to the suction mold for cold press of the wet blank. 冷压取件：冷压上模取湿胚上升到位。 CTM lift products (Cold press takes product off): the cold press upper mold takes the wet blank, and goes up to the required position; 冷压转移：冷压上模下降到转移位，转移湿胚到热压下模上后，自动返回，同时热压上模将制品脱落到输送带上。 Trans later wet products (Cold press transfer): the cold press up